Ansible supports configuring remote hosts using NETCONF (instead of the default SSH connection along with Linux shell commands). This guide explains how to leverage Ansible to configure multiple Virtual Service Router instances. Dependencies This guide assumes that you have two (or more) Virtual Service Router instances that are booted and accessible on the network (NETCONF […]
Tag: 6wind
PPPoE ipv6 6wind BNG using Radius Auth with SNAT64 Translation.
In this case we will use this topology: PPPoE Server First setup uplink for the internet side and link pppoe-client side, in this case we use dhcp on interface eth0 and just enable interface eth1 for pppoe-client. Next, setup pppoe-tunnel instance inside ppp-server menu with link-interface eth1. After setup pppoe-tunnel, it mandatory to setup authentication […]
PPPoE ipv4 6wind BNG using Radius Auth
In this case we will use this topology: PPPoE Server First setup uplink for the internet side and link pppoe-client side, in this case we use dhcp on interface eth0 and just enable interface eth1 for pppoe-client. Next, setup pppoe-tunnel instance inside ppp-server menu with link-interface eth1. After setup pppoe-tunnel, it mandatory to setup authentication […]
Integrate Authenticate 6wind using Radius.
Server Radius run the apt update and upgrade command below to update and refresh the package index on your system. Install Linux, Apache, MySQL, PHP (LAMP) stack on server. First, install Apach and once the installation is finished, you’ll need to adjust your firewall settings to allow HTTP traffic. Since this is a fresh Apache installation and […]
EVPN 6Wind
EVPN common configuration In EVPN, BGP must be configured to learn VNIs of local VXLAN interfaces, as follows: and the following configuration activates EVPN for the 10.10.1.2 neighbor.: and add interface vxlan and vni id to encapsulation vlan: and config on the neighbor peer :