In this case we will use this topology: PPPoE Server First setup uplink for the internet side and link pppoe-client side, in this case we use dhcp on interface eth0 and just enable interface eth1 for pppoe-client. Next, setup pppoe-tunnel instance inside ppp-server menu with link-interface eth1. After setup pppoe-tunnel, it mandatory to setup authentication […]
Tag: router 6wind
PPPoE ipv4 6wind BNG using Radius Auth
In this case we will use this topology: PPPoE Server First setup uplink for the internet side and link pppoe-client side, in this case we use dhcp on interface eth0 and just enable interface eth1 for pppoe-client. Next, setup pppoe-tunnel instance inside ppp-server menu with link-interface eth1. After setup pppoe-tunnel, it mandatory to setup authentication […]
Create DHCP Server on 6wind Router
State and enable DHCP server configuration. Define subnet and interface gateway on dhcp server. eg: gateway on interface eth1 with IP 192.168.10.1/24 Set default network address lease time assigned to DHCP clients for this subnet (in seconds, at least 180s). Set maximum network address lease time assigned to DHCP clients for this subnet (in seconds, […]
EVPN 6Wind
EVPN common configuration In EVPN, BGP must be configured to learn VNIs of local VXLAN interfaces, as follows: and the following configuration activates EVPN for the 10.10.1.2 neighbor.: and add interface vxlan and vni id to encapsulation vlan: and config on the neighbor peer :
Vlan on Router 6Wind
add sub interface vlan on physical interface. Add ip and its prefix on bridge interface if it needed.